5
NOTE:
• Be sure to attach the grass basket in the correct
position. Failure to do so may cause loss of grass
basket functionality.
Set mowing height
WARNING:
Before adjusting mowing height, turn OFF Power Switch,
unplug power cord from power socket, check that the
blade has come to a complete halt, and then make
adjustment.
• Attempting adjustment before blade has come to a
complete halt may cause injury.
Do not insert hands into gaps between wheels and main
unit cover or any other narrow spaces (gaps).
• Doing so may lead to hands becoming trapped, which
may cause injury. Furthermore, do not put hands under
main unit of device. The blade may cause injury.
1. Lock off button
2. Mowing height
adjustment lever
• There are six lawn height levels between
approximately 5 mm and 30 mm to choose from when
adjusting. Select desired height and adjust.
• Hold down the Lock OFF Button while moving the
Mowing Height Adjustment Lever backwards or
forwards to desired height setting. At this time, make
sure lever fits properly into selected height notch.
NOTE:
• The mowing height figures should be used just as a
guideline, as the state of the lawn or ground may cause
lawn height to be slightly different to the set height
figure.
Adjusting blade gap
WARNING:
Always turn OFF power switch and unplug the Electrical
Lawn Mower before commencing adjustment of blade
gap.
• Leaving the device plugged in when adjusting may
cause an accident.
CAUTION:
Always wear gloves when adjusting.
• Failure to do so may cause injury.
• To maintain a good cutting edge, regularly adjust the
gap between the cylinder blade and the fixed blade.
• Remove the two mounting screws from the side cover.
1. Screws
2. Side cover
To remove the side cover, slightly slide it in the direction of
arrow (1) and then raise it in the direction of arrow (2) as
shown in the figure.
1. Pulley
2. Lapping
adjustment
screws
• Turn over the main unit, and turn the left and right
lapping adjustment screws with a screwdriver to adjust
the blade gap. Next, manually turn the pulley to rotate
the cylinder blade, and evenly adjust the left and right
sides, so that the cylinder blades come into light
contact with the fixed blade and are capable of cutting
a piece of newspaper.
• Once adjusting is completed, remount the side cover
using the mounting screws with the above removal
procedures in reverse.
NOTE:
• If the contact between the cylinder blades and fixed
blade is too great, it will not only shorten the lifespan of
the blades, but also may cause belt and motor
damage.
Switch action
WARNING:
• Before plugging in the tool, always check to see
that the switch lever actuates properly and returns
to the “OFF” position when released.
1
2
(1)
(2)
1
2
1
2
