2
ENGLISH (Original instructions)
SPECIFICATIONS
Model
LH1201FL
Blade diameter
305 mm
Blade body thickness
1.9 mm or less
Hole diameter
For all countries other than European countries
25.4 mm
For European countries
30 mm
Max. Cutting capacities (H x W) with blade 305 mm in diameter in the miter saw mode
Miter angle
Bevel angle
90°
45° (left to right)
95 mm x 155 mm
95 mm x 110 mm
90°
62 mm x 200 mm
62 mm x 135 mm
64 mm x 155 mm
64 mm x 65 mm
45°
40 mm x 200 mm
40 mm x 85 mm
Max. Cutting capacities at 90° in the table saw (bench saw mode)
52 mm
No load speed (min
-1
)
3,800
Laser Type
Red Laser 650 nm,
1 mW (Laser Class 2)
Table size (W x L)
307 mm x 465 mm
Dimensions (L x W x H)
610 mm x 535 mm x 692 mm
Net weight
20.9 kg
Safety class
/II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END292-5
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE
INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When using the tool in the miter saw mode,
secure the top table at the topmost position
so that the saw blade never protrudes from
the top surface of the top table.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
･
Never look into the laser beam. Direct
laser beam may injure your eyes.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European
Directive, on Waste Electric and
Electronic Equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
ENE060-1
Intended use
The tool is intended for accurate straight cutting and
(only when used as a miter saw on the lower table) miter
cutting in wood.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
