R
epair
P 13 / 20
<15> Squaring adjustment of guide fence
<16> Repairing switch section
1. Set the bevel angle 90°.
2. Provisionally tighten M8x30 hex bolt (B) into the smaller screw hole on the left side of guide fence
when viewed from operator's position.
3. While checking the angle of guide rule to saw blade using 90 Degrees set square (No.1R208), pivot the guide fence
by moving its right end until the angle is 90 degrees.
4. After completion of squaring adjustment, securely tighten four M8x30 hex bolts; first A and D, then B and C.
Screw hole smaller
than the other 3 screw holes.
Saw blade
Handle cover can not be separated from switch box without removing lock lever of safety lock mechanism.
Remove lock lever as illustrated in Fig.8-1.
1. Remove handle cover, Now relay can be replaced. See Fig.13-1.
90 Degrees set square
(No.1R208)
A
B
D
C
Hex bolt M8x30
Hex bolt M8x30
Operator's position
When adjusting,
move this side.
Guide fence
Fig.12-1
Relay
Handle cover
Switch box
Fig.13-1
Fig.13-2
2. Do not forget to mount clamp plate and felt ring 6, when assembling switch section. And do not remove sponge
sheet from handle cover, when mounting it to switch box. Because these three parts protect the machine
against saw dust. See Fig.13-2.
Clamp plate
Pin
Felt rig 6
Pin
Switch box
Switch button OFF
Switch button ON
Handle cover
Sponge sheet
Motor housing
