![background image](http://html.mh-extra.com/html/makita/lf1000/lf1000_instruction-manual_232223013.webp)
13
CAUTION:
•
When turning the turn table, be sure to raise the
handle fully.
•
After changing the miter angle, always secure the
turn table by tightening the clamping screw firmly.
Adjusting the bevel angle
In the miter saw mode
Fig.11
Fig.12
To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise.
Push the handle to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale.
Then tighten the lever clockwise firmly to secure the
arm.
CAUTION:
•
When tilting the saw blade, be sure to raise the
handle fully.
•
After changing the bevel angle, always secure the
arm by tightening the lever clockwise.
In the table saw mode
Fig.13
To adjust the bevel angle, loosen the lever under the
table at the front of the tool counterclockwise.
Move the depth adjusting knob to the left to tilt the saw
blade until the pointer points to the desired angle on the
bevel scale. Then tighten the lever clockwise firmly to
secure the arm.
Switch action
Fig.14
Switch for the miter saw mode
CAUTION:
•
Before plugging in the tool, always check to see
that the switch lever actuates properly and returns
to the "OFF" position when released.
•
When not using the tool, remove the lock-off
button and store it in a secure place. This prevents
unauthorized operation.
•
Do not pull the switch lever hard without pressing
in the lock-off button. This can cause switch
breakage.
To prevent the switch lever from being accidentally
pulled, a lock-off button is provided. To start the tool,
push the lock lever to the left, press in the lock-off
button and then pull the switch lever. Release the switch
lever to stop.
Switch for the table saw mode
CAUTION:
•
Before operation, make sure that the tool is turned
on and off.
To start the tool, press the ON ( I ) button. To stop it,
press the OFF ( O ) button.
Adjusting the depth of cut
Fig.15
The depth of cut can be adjusted by turning the cutting
depth adjusting knob. Turn the cutting depth adjusting
knob clockwise to raise the blade or counterclockwise to
lower it.
WARNING:
•
Use a shallow depth setting when cutting thin
materials in order to obtain a cleaner cut.
CAUTION:
•
The stopper pin cannot be turned with the tool
head at fully lowered position. At this time, turn the
knob counterclockwise slightly and the stopper pin
can be released.
Fig.16
Overload protector
•
Tools for 200 V or higher power supply only. Refer
to nameplate on the tool for the rated voltage.
•
When the load on the tool exceeds admissible
levels, power to the motor is reduced to protect the
motor from overheating. When the load returns to
admissible levels, the tool will operate as normal.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Hex wrench storage
Fig.17
The hex wrench is stored as shown in the figure. When
using the hex wrench, pull it out of the wrench holder.
After using the hex wrench, return it to the wrench
holder.
Table height two-way set up
The table height can be set up in two ways, high or low
table.
WARNING:
•
Before falling down the tool backwards, always set
the tool in the miter saw mode and lock the tool
head in the lowest position.