Makita JV0600K-R, Инструкция по эксплуатации

Страница: 6 / 12

6
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing saw blade
CAUTION:
•
Always clean out all chips or foreign matter
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
•
Do not touch the blade or the workpiece
immediately after operation; they may be extremely
hot and could burn your skin.
•
Use only B type blades. Using blades other than B
type blades causes insufficient tightening of the
blade, resulting in a serious personal injury.
•
When you remove the saw blade, be careful not to
hurt your fingers with the top of the blade or the tips
of workpiece.
1
2
3
4
011959
1
012053
Before installing the blade, make sure that the blade
clamp lever is in the released position.
To install the blade, insert the blade (teeth facing forward)
into the blade holder until it latches. The lever moves to
the fixed position by itself and the blade is locked. Pull
the blade lightly to make sure that the blade does not fall
off during operation.
CAUTION:
•
If the lever does not move to the fixed position by
itself, the blade is not installed completely. Do not
press the lever by hand to the fixed position. It may
damage the tool. Make sure that the back edge of
the blade fits into the roller.
To remove the blade, push the lever forward as far as it
will go. This allows the blade to be released.
Hex wrench storage
1
2
011960
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
•
Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in a serious injury.
•
Advance the tool very slowly when cutting curves or
scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
•
Hold the tool firmly with one hand on the main
handle when performing the tool. If necessary, the
front part of the tool may be supported by the other
hand.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed.
1
2
011961
Then rest the base flat on the workpiece and gently move
the tool forward along the previously marked cutting line.
1. Cutting line
2. Base
1. Wrench holder
2. Hex wrench
1. Blade clamp
lever
1. Blade holder
2. Blade
3. Fixed position
4. Released
position