P 9/ 15
R
epair
7) While raising the end of bearing complete side, remove slider from slider support by pulling in the direction
of the arrow. (Fig. 19)
8) Remove X ring 14 from slider support. (Fig. 19)
1) Install X ring 14 on slider support. (Refer to Fig. 19.)
2) Put bearing complete on the motor side-end of slider, and plane bearing 14A on the blade side-end of slider. (Fig. 20)
Important: Bearing complete and plane bearing 14A are both not reversible when assembled to slider.
Be sure to place them so that the rib on bearing complete/ plane bearing 14A faces toward the motor side.
3) Mount slider to slider support. (Refer to Fig. 19.)
4) Fasten plate A and plate B to slider support as illustrated to left in Fig. 21.
5) Mount compression spring 5 (2 pcs) to slider support as illustrated to right in Fig. 21.
[3] -3. Disassembling/ Assembling Slider
DISASSEMBLING
ASSEMBLING
Fig. 19
Bearing complete
Slider
Plane bearing 14A
Fig. 20
Fig. 21
X ring 14
Plane bearing 14A
Bearing complete
Blade side
Motor side
Slider block
Slider
Plate A securing
plane bearing 14A
Plate B securing
bearing complete
Slider support
Slider support
Compression spring 5
Slider support
rib
rib
