Makita HR4030C, Инструкция по эксплуатации

Страница: 7 / 36

7
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Lubrication
This tool requires no hourly or daily lubrication because it
has a grease-packed lubrication system. Lubricate the
tool every time the carbon brushes are replaced. (Fig. 16
& 17)
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen three hex bolts which secure the crank cap cover
and remove the crank cap. Rest the tool on the table with
the bit end pointing upwards. This will allow the old
grease to collect inside the crank housing.
Wipe out the old grease inside and replace with a fresh
grease (60 g). Use only Makita genuine hammer grease
(optional accessory). Filling with more than the specified
amount of grease (approx. 60 g) can cause faulty ham-
mering action or tool failure. Fill only with the specified
amount of grease. (Fig. 18)
Reinstall the crank cap and crank cap cover and tighten
the three screws with the hex wrench.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by Mak-
ita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Tungsten carbide-tipped bit (Hexagonal)
• Tungsten carbide-tipped (hammer) bit
• Bull point
• Cold chisel
• Scaling chisel
• Clay spade
• Grooving chisel
• Rammer
• Bushing tool
• Hexagonal shank to various-Taper adapters
• Core bit
• Center bit
• Rod
• Core bit adapter
• Cotter (Drift key)
• Hammer grease
• Ground rod adapter
• Bit grease