W
iring diagram
P 18/ 20
[2] Wiring in Handle Sub Base
When Using Terminal Block
Connector of
Lead unit
rib B
rib C
rib A
pin
Important: Be careful not to route over the rib A.
Noise
suppressor
(if used)
Switch
Route each wire between the inside wall of Handle
sub base and the rib B/ rib C.
Pin
Pin
Terminal
block
Terminal
block
If Noise suppressor is used, wrap it with sponge,
and put in the space between the rib A and the rib B
so that the surface A of Noise suppressor is parallel
to the bottom of Handle sub base as illustrated to right.
Bottom of
Handle Sub Base
Terminal block
surface A
Noise suppressor
Sponge
1) Before installing Switch, connect the lead wires with Terminal blocks as illustrated in Fig. 52.
Fig. 52
boss
boss
to Switch
[Handle sub base viewed
from Handle side]
Motor side
Handle side
Before routing, be sure to put through the pipe of
Handle sub base from Motor side as illustrated below.
Route round the pin, then route between the boss and
the inside wall of Handle sub base.
Route round the pin and the rib B, then route between
the boss and the inside wall of Handle sub base.
Lead wires of Lead unit
Relay wires (white)
Lead wires of Power supply cord
Route each wire between the boss and the inside wall
of Handle sub base.
How to Put Noise Suppressor in Place
2) After installing Switch, connect the lead wires with Switch as illustrated in Fig. 53.
Fig. 53
rib B
rib D
Before routing, be sure to
put through the pipe of
Handle sub base from
Motor side as illustrated
to right.
Relay wires (white)
Relay wires (red)
Route each wire between the pin and the inside wall
of Handle sub base.
Lead wires of Noise suppressor
Be careful not to route over the ribs B and D.
3) After finishing the wiring in Sub handle base, route the
following lead wires through the opening of Top cover
and Rear cover as illustrated in Fig. 54:
Lead wires of Lead unit
Relay wires (red)
Fig. 54
Top cover
Rear cover
Handle sub cover
opening of the pipe
