Makita HG6031V, Инструкция по эксплуатации

Страница: 5 / 80

5
English
Q
Ensure adequate ventilation as toxic fumes
may be produced.
Q
Do not use as a hairdryer.
Q
Do not obstruct either the air intake or noz -
zle outlet, as this may cause excessive heat
build-up resulting in damage to the tool.
Q
Do not direct the hot air blast at other people.
Q
Do not touch the metal nozzle as it becomes
very hot during use and remains hot for up to
30 minutes after use.
Q
Do not place the nozzle against anything while
using or immediately after use.
Q
Do not poke anything down the nozzle as
it could give you an electric shock. Do not
look down the nozzle while the unit is work -
ing because of the high temperature being
produced.
Q
Do not allow paint to adhere to the nozzle or
scraper as it could ignite after some time.
Removing paint
Q
Do not use this tool to remove paint containing
lead. The peelings, residue and vapors of paint
may contain lead, which is poisonous. Any
pre-1960 building may have been painted in
the past with paint containing lead and cov -
ered with additional layers of paint.
Once deposited on surfaces, hand to mouth
contact can result in the ingestion of lead.
Exposure even to low levels of lead can cause
irreversible damage to the brain and nervous
system. Young and unborn children are partic -
ularly vulnerable.
Q
When removing paint, ensure that the work
area is enclosed. Preferably wear a dust mask.
Q
Do not burn the paint. Use the scraper and
keep the nozzle at least 25 mm away from the
painted surface. When working in a vertical
direction, work downwards to prevent paint
from falling into the tool and burning.
Q
Dispose of all paint debris safely and ensure
that the work area is thoroughly cleaned after
completing the work.
ASSEMBLY AND ADJUSTMENT
Prior to assembly and adjust -
ment, always unplug the tool
.
The air temperature can be adjusted to suit a wide
range of applications. The table below suggests set-
tings for different applications.
Setting Applications
HG6030: 1
Q
Cooling the hot parts.
Q
Cooling the machines before
changing the nozzle.
HG5030: 1
HG6031V: 1
HG6030: 2
Q
Drying paint and varnish.
Q
Removing stickers.
Q
Waxing and de-waxing.
Q
Drying wet timber prior to filling.
Q
Shrinking PVC wrapping and
insulation tubes.
Q
Thawing frozen pipes.
HG5030: 2
HG6031V: 2
HG6030: 3
Q
Welding plastics.
Q
Bending plastic pipes and
sheets.
Q
Loosening rusted or tightly
fastened nuts and bolts.
Q
Removing paint and lacquer.
Q
Soldering plumbing joints.
If you are not sure about the correct
setting, start with a low temperature
setting and gradually increase the
temperature until you achieve opti -
mum results.