![background image](http://html.mh-extra.com/html/makita/hb500/hb500_original-instruction_225832006.webp)
10
en
11
en
• To
p
ower
u
p
the
m
aChine
,
press and release
the red button Fig. 5
• To
e
nergiSe
the
m
agnet
,
press and release
the yellow button - the yellow lED will light
Fig. 6.
RECHECK
the pilot is still centred on the hole
position - energising the magnet can sometimes
cause the unit to move slightly from the centre
mark, reposition if necessary.
• The magnet will hold on all ferrous materials
from a minimum of 6mm (1/4”) thickness.
STARTINg THE CUT
•
alwayS
lower the safety guard.
•
S
tart
the
motor
by pressing and releasing
the green button - the green lED will light
Fig. 7.
• wind the cutter gently down to the surface
of the work and apply light pressure until
the cutter has made the initial groove in the
surface. Increase the pressure until the motor
is loaded Fig. 8.
• Maintain steady pressure throughout the rest
of the cut. Too much pressure will not speed
the cut, it will reduce the life of the cutter and
may cause damage to the motor. If the shavings
become blue add more oil.
startinG the cut
N.B. Safety strap has been omitted from the photo’s for clarity.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
• to stop the motor,
PRESS & RElEASE gREEN BUTTON.
• If the cutter jams in the workpiece,
Stop
the
motor
and gently raise the cutter out of the
workpiece before re-starting.
• If the power is interrupted during the cut,
the machine must be reset before the motor
will restart.
• At the end of the cut, the slug will be ejected.
withdraw the cutter from the work piece and
stop the motor.
• To disengage the magnet, press and release
the yellow button - the magnet will not
disengage immediately, there will be a 3 second
delay before the magnet disengages along with
a continuous beep.
INCORRECT START UP OR SHUT DOwN
SEqUENCE:-
• A single beep will be heard for all operations
carried out in the correct sequence. A
continuous beep will sound for any incorrect
sequence.
• Neither drill nor magnet can be operated until
red power button is activated.
• when the red power button is activated, the
motor will not run until the magnet is activated.
p
ower
u
p
the
m
aChine
e
nergiSe
the
m
agnet
S
tart
the
motor
S
tart
the
C
ut
N.B. Safety strap has been omitted from the photo’s for clarity.
Содержание HB500
Страница 30: ...Notes Notes ...
Страница 31: ...60 Makita Corporation Anjo Aichi Japan www makita com ...