![background image](http://html1.mh-extra.com/html/makita/gvj02/gvj02_instruction-manual_4404677007.webp)
7 ENGLISH
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the “OFF” position when released.
To turn on the tool, press the lock switch. The tool turns
into the standby mode. To start the tool, pull the switch
trigger in the standby mode. Tool speed is increased by
increasing pressure on the switch trigger.
To stop the tool, release the switch trigger. The tool
turns into the standby mode. To turn off the tool, press
the lock switch in the standby mode.
For continuous operation, pull the switch trigger in the
standby mode, and then push in the lock on button.
To stop the tool, pull the switch trigger fully, and then
release it.
1
2
3
Fig.4
►
1.
Lock switch
2.
Lock on button
3.
Switch trigger
NOTE:
If the tool is left for 10 seconds without any
operation in the standby mode, the tool automatically
turns off and the lamp goes off.
NOTE:
The lock switch is not available while the tool
is operating.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Press the lock switch to turn on the lamp. Press the lock
switch again to turn off the lamp.
1
2
Fig.5
►
1.
Lock switch
2.
Lamp
The brightness has three levels. To decrease the bright-
ness of the lamp, press and hold the lock switch when
turning on the tool. About 1 second after pressing and
holding the lock switch, the brightness of the lamp will
start to decrease. The brightness returns to the highest
level from the lowest level and repeats the decrease.
Release the lock switch when you reach the desired
brightness.
NOTICE:
When the tool is overheated, the lamp
blinks. Cool down the tool fully before operating
the tool again.
NOTE:
Press and hold the lock switch continuously to
cycle through the three brightness levels.
NOTE:
The brightness of the lamp cannot be
adjusted while the tool is in standby mode. To adjust
the brightness, turn the tool off and then on again.
NOTE:
The lamp lights up at the same brightness
level as the last time the tool was used.
NOTE:
Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Speed adjusting dial
1
Fig.6
►
1.
Speed adjusting dial
The tool speed can be adjusted by turning the speed
adjusting dial. You can get the highest speed at 6 and
the lowest speed at 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the jig saw blade will be
reduced.
Workpiece
Number
Wood
4 - 6
Mild steel
3 - 6
Stainless steel
3 - 4
Aluminum
3 - 6
Plastics
1 - 4
NOTICE:
The speed adjusting dial can be turned
only as far as 6 and back to 1. Do not force it past
6 or 1, or the speed adjusting function may no
longer work.