![background image](http://html1.mh-extra.com/html/makita/gru04/gru04_instruction-manual_4258198013.webp)
13 ENGLISH
Attach the protector to the clamp using bolts.
1
2
3
►
1.
Clamp
2.
Protector
3.
Cutter
Installing the cutting tool
CAUTION:
Always use the supplied
wrench(es) to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the
cutting tool.
NOTE:
The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries.
NOTE:
Turn the tool upside down so that you can
replace the cutting tool easily.
Nylon cutting head
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
4
5
3
1
2
►
1.
Nylon cutting head
2.
Spindle
3.
Hex wrench
4.
Loosen
5.
Tighten
1.
Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
Place the nylon cutting head onto the spindle and
tighten it securely by hand.
3.
Remove the hex wrench from the gear case.
To remove the nylon cutting head, follow the installation
procedures in reverse.
OPERATION
Attaching the shoulder harness
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity.
Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
CAUTION:
Always use the shoulder harness
attached to the tool. Before operation, adjust the
shoulder harness according to the user size to
prevent fatigue.
CAUTION:
Before operation, make sure that
the shoulder harness is properly attached to the
hanger on the tool.
CAUTION:
When you use the tool in combi-
nation of the backpack-type power supply such
as portable power pack, do not use the shoulder
harness included in the tool package, but use the
hanging band recommended by Makita.
If you put on the shoulder harness included in the
tool package and the shoulder harness of the back-
pack-type power supply at the same time, removing
the tool or backpack-type power supply is difficult in
case of an emergency, and it may cause an accident
or injury. For the recommended hanging band, ask
Makita Authorized Service Centers.
1.
Clasp the hook on the shoulder harness to tool's
ring and hanger.
1
2
3
2
►
1.
Ring
2.
Hook
3.
Hanger
Содержание GRU04
Страница 16: ...16 ENGLISH 96 M10L 1 2 4 3 5 6 4 m 13 ft 100 mm 3 15 16 ...
Страница 32: ...32 ESPAÑOL 96 M10L 1 2 4 3 5 6 4 m 13 ft 100 mm 3 15 16 ...
Страница 34: ...34 ...
Страница 35: ...35 ...