11 ENGLISH
2.
While pushing the lock lever toward A, push in the wheel
guard by holding down the portions B as shown in the figure.
2
B
1
A
B
►
1.
Wheel guard
2.
Hole
NOTE:
Push down the wheel guard straight. Otherwise,
you cannot push the wheel guard completely.
3.
While keeping the lock lever and wheel guard position as
described in step 2, rotate the wheel guard toward C, and then,
change the angle of the wheel guard according to the work.
2
B
1
A
B
B
C
C
►
1.
Wheel guard
2.
Hole
NOTE:
Push the wheel guard completely. Otherwise,
you cannot rotate the wheel guard.
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing or removing depressed
center wheel or flap disc
Optional accessory
WARNING:
When using a depressed center
wheel or flap disc, the wheel guard must be fitted
on the tool so that the closed side of the guard
always points toward the operator.
CAUTION:
Make sure that the mounting part
of the inner flange fits into the inner diameter of
the depressed center wheel / flap disc perfectly.
Mounting the inner flange on the wrong side may
result in the dangerous vibration.
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the depressed center wheel / flap disc on the inner
flange and screw the lock nut onto the spindle.
3
2
4
1
►
1.
Lock nut
2.
Depressed center wheel
3.
Inner
flange
4.
Mounting part
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
1
2
►
1.
Lock nut wrench
2.
Shaft lock
To remove the wheel, follow the installation procedure
in reverse.
