5
ENGLISH (Original instructions)
Explanation of general view
SPECIFICATIONS
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
END202-8
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
.................. Only for EU countries
Do not dispose of electric equipment
together with household waste
material!
In observance of the European
Directive, on Waste Electric and
Electronic Equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
Intended use
ENE048-1
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
ENF002-2
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For model GA7050, GA9050
ENF100-1
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.22 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
1.
Shaft lock
2.
Switch trigger
3.
Lock lever
4.
Indication lamp
5.
Wheel guard
6.
Screw
7.
Bearing box
8.
Nut
9.
Lever
10. Lock nut
11. Depressed center wheel
12. Inner flange
13. Super flange
14. Lock nut wrench
15. Abrasive disc
16. Rubber pad
17. Ezynut
18. Abrasive wheel/Multi-disc
19. Spindle
20. Arrow
21. Notch
22. Wire cup brush
23. Wire wheel brush
24. Abrasive cut-off wheel/diamond
wheel
25. Wheel guard for abrasive cut-off
wheel/diamond wheel
26. Outer flange 78
27. Inner flange 78
28. Exhaust vent
29. Inhalation vent
30. Commutator
31. Insulating tip
32. Carbon brush
33. Brush holder cap
34. Screwdriver
Model
GA7050
GA7050R
GA9050
GA9050R
Depressed center wheel
diameter
180 mm
230 mm
Max. wheel thickness
6.5 mm
Spindle thread
M14 or 5/8” (country specific)
No load speed (n
0
)/
Rated speed (n)
8,500 (min
-1
)
6,600(min
-1
)
Overall length
432 mm
455 mm
432 mm
455 mm
Net weight
4.5 kg
4.6 kg
4.7 kg
4.8 kg
Safety class
/II
