Makita EB5300TH, Инструкция по эксплуатации

Страница: 19 / 24

19 ENGLISH
1. Loosen the fixing nut.
2. If the throttle valve does not touch the throt-
tle valve stopper, turn the cable adjusting bolt
counterclockwise.
If the throttle valve does not touch the idling adjusting
screw, turn the cable adjusting bolt clockwise.
1
2
► 1. Cable adjusting bolt 2. Fixing nut
3. Tighten the fixing nut to fasten the cable adjusting bolt.
4. Check the movement of the throttle valve. The
throttle valve comes to the position as illustrated when
the throttle trigger/lever is pulled/turned.
Cleaning carburetor cover
If the carburetor cover gets dirty and it is difficult to
check the throttle valve, clean the carburetor cover as
follows:
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like for cleaning the carburetor
cover.
Otherwise it may be tarnished.
1. Pass a slotted screwdriver through the hole on the
engine cover. Release the clamp of the carburetor cover.
1
► 1. Carburetor cover
2. Clean the carburetor cover.
NOTICE:
Use wet clean cloth for cleaning the
carburetor cover.
3. Return the carburetor cover. Make sure the clamp
of the carburetor cover clicks when it is set in place.
Inspecting bolts, nuts and screws
and other parts
Retighten loose bolts, nuts, etc.
Check for fuel and oil leakage.
Replace damaged parts with new ones for safety operation.
Cleaning engine, cooling air inlet
Keep engine clean by wiping down with a cloth rag.
Keep the cylinder fins free of dust or dirt. Dust or dirt adhering
to the fins may cause engine overheat and piston seizure.
Blowing air is taken in from the air inlet vent. When
airflow drops down during operation, stop engine and
inspect the air inlet vent for any blockages. Clean it if
necessary. Such a blockage may cause overheat and
damage the engine.