7 ENGLISH
•
When the cleaner is overloaded:
At this time, press the "OFF" button and
remove causes of overload and then press
the "HIGH/LOW" button again to restart.
•
When battery cells get hot: (refer to the note below.)
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, stop use of the cleaner
and cool or charge the battery cartridge after
removing it from the cleaner.
•
When the remaining battery capacity gets low:
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, remove the battery
cartridge from the cleaner and charge it.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
1
2
►
1.
Indicator lamps
2.
Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Remaining
capacity
Lighted
Off
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE:
Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE:
The first (far left) indicator lamp will blink when
the battery protection system works.
Switch action
1
2
►
1.
HIGH/LOW button
2.
OFF button
To start the cleaner, simply press the "HIGH/LOW"
button. To switch off, press the "OFF" button. To change
the cleaner speed, press the "HIGH/LOW" button. The
first press on this button is for high speed and the sec
-
ond press for low speed and then each press on this
button repeats the high/low speed cycle alternatively.
ASSEMBLY
CAUTION:
•
Always be sure that the cleaner is switched off
and the battery cartridge is removed before
carrying out any work on the cleaner.
•
Any work with the battery cartridge being
installed on the cleaner may cause a personal
injury or damage to the objects around the
cleaner.
Installing dust bag
1
2
3
4
►
1.
Dust outlet
2.
Dust bag joint
3.
Pins
4.
Dust bag
Hold the square section of the dust bag joint and fit the
pins inside the dust bag joint to the notches in the dust
outlet of the cleaner and then insert and turn it clock-
wise all the way until it stops.