10 ENGLISH
Adjusting the pipe length
CAUTION:
When adjusting the pipe length,
hold the tool horizontally.
Otherwise, the pipe
length may change unintentionally and it may cause
an injury or malfunction of the tool.
NOTICE:
Do not extend the pipe beyond the
limit.
Failure to do so may cause a malfunction of
the tool.
2
1
►
1.
Sleeve
2.
Pipe
To adjust the pipe length, loosen the sleeve, then adjust
the length of the pipe, and then tighten the sleeve.
Hex wrench storage
1
►
1.
Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing or removing the pad
1
2
3
►
1.
Hex wrench
2.
Bolt
3.
Pad
To remove the pad, remove the abrasive disc from the
pad, and then turn the bolt counterclockwise with a hex
wrench. To install the pad, perform the removal proce-
dure in reverse.
CAUTION:
Make sure that the pad is secured
properly.
Loose attachment will run out of balance
and cause an excessive vibration which may cause
loss of control.
Connecting a vacuum cleaner
Optional accessory
When you wish to perform operation cleanly, connect a
Makita vacuum cleaner to your tool. Connect a hose of
the vacuum cleaner to the dust nozzle using the front
cuff 24.
1
2
3
►
1.
Hose of the vacuum cleaner
2.
Front cuff 24
3.
Dust nozzle
