![background image](http://html.mh-extra.com/html/makita/dpj180/dpj180_instruction-manual_230434007.webp)
7
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
1
2
3
4
012498
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade
thickness.
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
•
Remove the angle guide according to the need of
your work when using the tool with the angle of the
fence adjusted to other than 0
゚
. When you need to
use the angle guide under the above condition, be
sure to adjust the depth of groove to get a proper
depth.
1
2
3
4
5
012499
1
2
3
4
5
10mm
10mm
012500
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
When the fence is set at 90°, both the distance from the
center of the blade thickness to the fence and the
distance from the center of the blade thickness to the
bottom of the blade cover are 10 mm (0.4").
Set plate
6mm
1
2
3
4
5:
6
7
4mm
10mm
10mm
012258
1
012501
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
Switch action
1
012512
CAUTION:
•
Before installing the battery cartridge into the tool,
always check to see that the slide switch actuates
properly and returns to the "OFF" position when
the rear of the slide switch is depressed.
•
Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I (ON)"
position. For continuous operation, press the front of the
slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
1. Slide switch
1. Set plate
1. Lock lever
2. Pointer
3. Angle scale
4. Set plate
5. Thickness of set
plate
6. Center of blade
thickness
7. Blade cover
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Blade cover
1. Fence
2. Angle scale
3. Lock lever
4. Tighten
5. Loosen
1. Knob
2. Down
3. Up
4. Center of blade
thickness