Makita DGA464, Инструкция по эксплуатации

Страница: 26 / 240

26 ENGLISH
If you wish to activate the vacuum cleaner along with the
switch operation of the tool, finish the tool registration
beforehand.
1. Install the batteries to the vacuum cleaner
and the tool.
2. Set the stand-by switch on the vacuum
cleaner to "AUTO".
►
Fig.30: 1. Stand-by switch
3. Press the wireless activation button on the
vacuum cleaner for 3 seconds until the wireless
activation lamp blinks in green. And then press the
wireless activation button on the tool in the same way.
►
Fig.31: 1. Wireless activation button 2. Wireless
activation lamp
If the vacuum cleaner and the tool are linked
successfully, the wireless activation lamps will light up in
green for 2 seconds and start blinking in blue.
NOTE: The wireless activation lamps finish blinking in
green after 20 seconds elapsed. Press the wireless
activation button on the tool while the wireless
activation lamp on the cleaner is blinking. If the
wireless activation lamp does not blink in green, push
the wireless activation button briefly and hold it down
again.
NOTE: When performing two or more tool registrations
for one vacuum cleaner, finish the tool registration one
by one.
Starting the wireless activation
function
NOTE: Finish the tool registration for the vacuum
cleaner prior to the wireless activation.
NOTE: Refer to the instruction manual of the vacuum
cleaner, too.
After registering a tool to the vacuum cleaner, the
vacuum cleaner will automatically runs along with the
switch operation of the tool.
1. Install the wireless unit to the tool.
2. Connect the hose of the vacuum cleaner with the
tool.
►
Fig.32
3. Set the stand-by switch on the vacuum cleaner to
"AUTO".
►
Fig.33: 1. Stand-by switch
4. Push the wireless activation button on the tool
briefly. The wireless activation lamp will blink in
blue.
►
Fig.34: 1. Wireless activation button 2. Wireless
activation lamp
5. Pull the switch trigger of the tool. Check if the
vacuum cleaner runs while the switch trigger is
being pulled.
To stop the wireless activation of the vacuum cleaner,
push the wireless activation button on the tool.
NOTE: The wireless activation lamp on the tool will
stop blinking in blue when there is no operation for 2
hours. In this case, set the stand-by switch on the
vacuum cleaner to "AUTO" and push the wireless
activation button on the tool again.
NOTE: The vacuum cleaner starts/stops with a delay.
There is a time lag when the vacuum cleaner detects
a switch operation of the tool.
NOTE: The transmission distance of the wireless unit
may vary depending on the location and surrounding
circumstances.
NOTE: When two or more tools are registered to one
vacuum cleaner, the vacuum cleaner may start
running even if you don't pull the switch trigger
because an other user is using the wireless activation
function.
Description of the wireless activation lamp status
►
Fig.35: 1. Wireless activation lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the table below for the
meaning of the lamp status.
Status Wireless activation lamp Description
Color
On Blinking
Duration
Standby Blue 2 hours The wireless activation of the vacuum cleaner is available. The
lamp will automatically turn off when no operation is performed for
2 hours.