Makita DGA462, Инструкция по эксплуатации

Страница: 17 / 28

17 ENGLISH
1
2
3
4
►
1. Lock nut 2.
Abrasive cut-off wheel / diamond
wheel 3.
Inner flange
4. Wheel guard for abrasive
cut-off wheel / diamond wheel
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner flange varies by wheel type and thickness.
Refer to the following figures.
For 100 mm (4″) model
When installing the abrasive cut-off wheel:
16 mm (5/8″) 16 mm (5/8″)
1 1
4
4
2 3
►
1. Lock nut 2.
Abrasive cut-off wheel (Thinner than
4mm (5/32"))
3.
Abrasive cut-off wheel (4mm (5/32")
or thicker)
4.
Inner flange
When installing the diamond wheel:
1 1
4
4
2 3
►
1. Lock nut 2.
Diamond wheel (Thinner than 4mm
(5/32″))
3.
Diamond wheel (4mm (5/32″) or thicker)
4.
Inner flange
For 115 mm (4 - 1/2″) / 125 mm (5″)
model
When installing the abrasive cut-off wheel:
1 1
4 4
2 3
►
1. Lock nut 2.
Abrasive cut-off wheel (Thinner than
4mm (5/32"))
3.
Abrasive cut-off wheel (4mm (5/32")
or thicker)
4.
Inner flange
When installing the diamond wheel:
1 1
4 4
2 3
►
1. Lock nut 2.
Diamond wheel (Thinner than 4mm
(5/32″))
3.
Diamond wheel (4mm (5/32″) or thicker)
4.
Inner flange
Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.