![background image](http://html1.mh-extra.com/html/makita/dcs550/dcs550_technical-information_3901129012.webp)
P 12/13
W
iring diagram
[Blade case viewed from Handle R side]
Lead wire holder
Protective tube
Fix Protective tube that covers LED lead wires
with Lead wire holder on Blade case.
Pull out LED lead wires from the hole in Blade case
as illustrated below.
Connector
Connector
LED circuit
Fig. D-2
[1] Wiring of LED Lead Wire on Blade Case
Route as illustrated in Figs. D-2, D-3.
Fig. D-3
opening
Handle R
Blade case
[2] Wiring Lead Wires of Endbell Complete in/on Motor Section
through hole
Pull out from this through hole.
Endbell complete
Fig. D-4
Fig. D-5
groove
Housing L
Housing R
Housing L
1) Route on the inside of Housing L as illustrated in Fig. D-4.
Note: Assemble Housing R to Housing L after completion of wiring on the inside of Housing L.
2) Route on the front of Housing R as illustrated in Fig. D-5.
Note: Assemble Gear housing to Motor section after completion of wiring on the front of Housing R.
Lead wire holder
Fix Lead wires with
these Lead wire holders.
Lead wire holder
through hole
[Motor section viewed from front]
Fix with Lead wire holder.
Route through this groove.