![background image](http://html1.mh-extra.com/html/makita/dcg180zbk/dcg180zbk_instruction-manual_3913952007.webp)
7
Lighting up the lamp
CAUTION:
•
Do not look in the light or see the source of light directly.
1
013570
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after the
switch trigger is released.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
•
When the tool is overheated, the lamp flickers.
Cool down the tool fully before operating again.
Drip preventive function
The motor keeps running for a short time even after the
trigger is released. It releases the pressure of the
caulking material and prevents dripping.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
•
Always place the tool on the ground or workbench when
carrying out any assembling work. The tool without
being held tight may loose balance and cause injury.
Installing holder joint
013610
Attach the holder joint firmly along the tool, set the plate,
and fix them with screws tightly.
To remove the holder joint, follow above procedure in reverse.
NOTE:
•
There are two types of holders (optional
accessory), short holder (300ml) and long holder
(600ml). Use appropriate holder joint accordingly.
Installing rod and piston
A
B
C
013612
A
B
C
013611
Insert the rod into the slit of the tool.
Attach the piston and tighten it with a screw.
To remove the rod and piston, follow the installation
procedure in reverse.
NOTICE:
•
The teeth on the rod must point down.
•
There are three types of pistons. Piston A for
cartridges. Piston B for film type packs. Piston C
for direct filling.
•
Choose appropriate piston in accordance with the
type of caulking material container. Improper
piston may cause leakage or tool breakage.
•
There are two types of rods. The short rod for the
short holder (300ml), and the long rod for long
holder (600ml). Use appropriate rod in accordance
with holder type.
•
Always keep the rod and piston clean. Adhering
caulk may damage the tool.
1. Lamp