![background image](http://html.mh-extra.com/html/makita/bss730/bss730_instruction-manual_230311017.webp)
17
Adjusting for accuracy of 90° and 45° cut
(vertical and 45° cut)
This adjustment has been made at the factory. But if it is off,
adjust the adjusting screws with a hex wrench while inspect-
ing 90° or 45° the blade with the base using a triangular rule
or square rule, etc.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
After replacing brushes, insert the battery cartridge into the
tool and break in brushes by running tool with no load for
about 1 minute. Then check the tool while running and elec-
tric brake operation when releasing the switch trigger. If elec-
tric brake is not working well, ask your local Makita service
center for repair.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
1. Adjusting screw for 90°
2. Adjusting screw for 45°
1. Triangular rule
2
1
001503
1
45
°
90
°
001512
1. Limit mark
1
001145
1. Brush holder cap
2. Screwdriver
1
2
001527
Содержание BSS730
Страница 19: ...Memo 19 ...
Страница 20: ...Memo 20 ...
Страница 21: ...21 Fold Cut Stamp Timbre Makita Canada Inc 1950 Forbes Street Whitby Ontario L1N 7B7 ...