P 10/ 13
[3] DISASSEMBLY/ASSEMBLY
[3] -6. Switch Mechanism (cont.)
R
epair
ASSEMBLE
Fig. 38
Fig. 39
Fig. 41
Fig. 42
Fig. 40
7) Insert the remaining two Pins 2.5 firmly into Housing set L until
they stop as illustrated in Fig. 38.
8) Install Link plate to Housing L with Pin 3 through Link plate. (Fig. 39)
9) Insert the projection of Light switch arm into Compression spring 2
firmly. And then insert the axis of Light switch arm into hole of
Housing L and push Compression spring 2 to the emboss of Housing L.
(Fig. 40)
10) Set Torsion spring 4 in place. Install Safety trigger and Torsion spring 4
to Housing L with Pin 3 as illustrated in Fig. 41.
12) As illustrated in Fig. 42, the relevant parts are assembled.
Pin 2.5 (two pcs.)
Pin 2.5
(Ref. Figs. 34 and 35)
Pin 3
Link plate
Compression
spring 2
Emboss of
Housing L
Torsion spring 4
Safety trigger
Pin 3
Axis of Light
switch arm
Hole of Housing L
for Light switch arm
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Magazine
DISASSEMBLE
Caution of ASSEMBLE
Shoulder pin 5-7 (orange color)
Spring pin 3-18
Lever
Spring pin 2-8
Nail guide holder
Upper rail complete
Upper rail
complete
Pusher
Nail stopper: 3 pcs.
1) Pull off Upper rail complete from Magazine after removing M4x6 Hex socket
head bolt. Refer to Fig. 10.
2) Pusher is just inserted into the slit of Shoulder pin 5-7. Therefore, Pull Pusher
off from the slit simply. (Fig. 43)
3) Remove three Nail stoppers by pushing toward the direction designated with
black arrow in Fig. 44.
4) Use 1R266 to remove Spring pin 2-8 from Nail guide holder.
Use 1R267 to remove Spring pin 3-18 from Lever. (Fig. 45)
Fig. 43
Fig. 44
Fig. 45
Fig. 46
Lever
Upper rail
complete
Slide door cap
When installing Slide door cap into Upper rail complete,
press Slide door cap fully to designated direction as illustrated
in Fig. 46 and tighten M4x10 Pan head screw at the same time.
While facing the slit of Shoulder pin 5-7 to the magazine side
as illustrated in Fig. 43, install Pusher to Upper rail complete.
