Makita BGD800, Инструкция по эксплуатации

Страница: 8 / 56

8
Fig.9
Insert the top end of slotted bit screwdriver into the
notch in the tool and remove the holder cap cover by
lifting it up.
Fig.10
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Reinstall the holder cap cover on the tool.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Side handle (accessory)
Fig.11
Fig.12
Fig.13
Fig.14
When using the side handle, remove the rubber
protector, insert the side handle on the tool barrel as far
as it will go and rotate it to the desired angle. Then
tighten the handle firmly by turning clockwise.
CAUTION:
•
When using the tool without handle, always install
the rubber protector on the tool.
•
When installing the rubber protector, always push
it onto the tool so that the top round recessed
shape of the rubber is positioned near the switch
position.
•
Wheel points
•
Collet cone (3 mm, 6 mm, 8 mm, 1/4", 1/8")
•
Collet nut
•
Wrench 13
•
Side handle set
•
Makita genuine battery and charger
NOTE:
•
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.