P 8/ 11
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Motor Complete, Gear Assembly (cont.)
ASSEMBLING
Fig. 12
Fig. 11
(9) When replacing the whole Gear assembly, use new Gear assembly as drawn in
Fig. 12
.
(8) Assemble the driving section (Gear assembly and Motor complete) to Housing (L) complete as drawn in
Fig. 11
.
Compression spring 6
3. Gear assembly is pushed by Compression spring 6
toward Sub controller, and it may not be fitted
within the rib on Housing (L) complete at the motor
portion. So, push Gear assembly toward the direction
of the black arrow shown below to set it within the rib.
Compression spring 6
Rib
Magnet
Magnet
Rib
Sub controller
Compression
spring 6
1. Mount Compression spring 6 to Magnet
in Gear housing.
4. Make sure that Compression spring 6
fits inside the space.
2. Fit Compression spring 6 to the rib on
Housing (L) complete with pressing
it toward Magnet.
1. Remove three 3x16 Tapping screws and Gear housing cover from Gear assembly.
2. Assemble Motor complete with Gear housing cover to new Gear assembly
with three 3x16 Tapping screws.
Note
: Scrap Removed Gear housing cover and three 3x16 Tapping screws.
Motor complete
Gear housing cover
(the component of Motor complete)
3x16 Tapping screw (3 pcs.)
Main body of
Gear assembly
