7
Installing or removing abrasive disc
(optional accessory)
NOTE:
•
Use sander accessories specified in this manual. These
must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
IF USED AS A GRINDER
NOTE:
•
Use grinder accessories specified in this manual. These
must be purchased by separate.
WARNING:
•
Always use guard assembly or accessory kit, noted
below, for type 27 depressed center grinding wheel/
Multi-disc.
•
Guard assembly
Part No. 192578-8 ... For 180 mm (7”)
Part No. 192588-5 ... For 230 mm (9”)
Guard accessory kit
Part No. 192606-9 ... For 180 mm (7”)
Part No. 192607-7 ... For 230 mm (9”)
1. Lock nut
2. Abrasive disc
3. Rubber pad
1
3
2
001112
1. Lock nut wrench
2. Shaft lock
001622
1
2
