Makita 6304LR, Инструкция по эксплуатации

Страница: 7 / 16

7
Installing or removing drill bit
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each of
the three holes and tighten clockwise. Be sure to tighten all
three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just
one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the original
position.
Depth gauge (optional accessory)
The depth gauge is convenient for drilling holes of uniform
depth.
Loosen the side grip and remove it. Fit the convex on the
stopper holder to the concave on the tool barrel. Insert the
side grip into the stopper holder and screw the side grip.
Insert the depth gauge into the hole in the stopper holder.
Adjust the depth gauge to the desired depth and tighten the
side grip firmly.
1. Chuck key
1
003056
1. Stopper holder
2. Depth gauge
3. Side grip
4. Convex
5. Concave
1
2
3
4
5
003060
1. Depth gauge
2. Side grip
1
2
003061