R
epair
P 5 / 15
Face the roll portion
to the opposite side
of Gear housing cover
Gear housing cover
Leaf spring
3. After aligning the holes of Slider and Rod, insert Pin 4 into the aligned hole from left side as illustrated in Fig. 11.
4. Recline Slider fully and insert a pair of Linear guides as illustrated in Fig. 12.
5. While lifting up the flat side of Leaf spring, lay a pair of Linear guides to put the flat side of Leaf spring on Linear
guides as illustrated in Fig. 13.
6. Move Slider to the center of Linear guides. Fasten Linear guides with four M4x10 Pan head screws as illustrated in Fig. 14.
1. Assemble Tool opener to Gear housing cover with referring to Figs. 1, 2 and 3 in page 3.
2. Put Leaf spring in Gear housing cover. Pay attention to its assembling direction. (Fig. 9)
Insert Rod into Gear housing cover. Pay attention to the direction of the hook of Blade holder as illustrated in Fig. 10.
[6] Assembling Gear housing cover section
Tool opener
Rod
ass'y
Hook of Blade holder
Face the hook of Blade
holder to the hook of
Tool opener when installing
Rod ass'y. Refer to Fig. 10.
Hook of Blade holder
Gear housing cover
Hook of Tool opener
Lift up the flat side
of Leaf spring.
Lay Linear guides.
Leaf spring
Linear guides
Gear housing cover
Note:
Linear guides have to be
put between Gear housing
cover and the flat side of
Leaf spring.
Slider
Move Slider to the
center of Linear guides.
Note: Attach the ends of Linear guides to the two protrusions
in the Gear housing cover when fastening them.
Pan head screws M4x10
Fig. 9
Fig. 11
Fig. 13
Fig. 14
Fig. 12
Fig. 10
Hole of Rod
Holes of Slider
Pin 4
(to the aligned hole)
Linear guides
View in Gear housing cover
Slider
The ends of Linear guides
The two protrusions in
the Gear housing cover
