4 ENGLISH
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
1
2
►
1.
Lock button / Lock-off button
2.
Switch trigger
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
For Model 2107F
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
For Model 2107FZ
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
•
NEVER use tool without a fully operative
switch trigger.
Any tool with an inoperative
switch is HIGHLY DANGEROUS and must be
repaired before further usage or serious per-
sonal injury may occur.
•
For your safety, this tool is equipped with a lock-
off button which prevents the tool from unin-
tended starting. NEVER use the tool if it runs
when you simply pull the switch trigger without
pressing the lock-off button. A switch in need of
repair may result in unintentional operation and
serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE fur-
ther usage.
•
NEVER defeat the lock-off button by taping
down or some other means. A switch with a
defeated lock-off button may result in uninten-
tional operation and serious personal injury.
Speed adjusting dial
1
►
1.
Speed adjusting dial
The tool speed can be infinitely adjusted between 1.0
m/s and 1.7 m/s by turning the adjusting dial. Higher
speed is obtained when the dial is turned in the direc-
tion of number 5; lower speed is obtained when it is
turned in the direction of number 1.
Select the proper speed for the workpiece to be cut.
CAUTION:
•
The speed adjusting dial can be turned only as
far as 5 and back to 1. Do not force it past 5 or
1, or the speed adjusting function may no longer
work.
