24
are the basic settings, by default, reverse pumping is allowed.
Effect:
If the length of the reverse withdrawal wire is too short, it may cause wire
drawing. If it is too long, may not produce filament.
3.
Initial layer height:
The first layer thickness.
Effect:
The first layer is set thicker to allow the model to stick tighter.
4.
Cut off the bottom:
When some models are uneven at the bottom, or when there are
few contact surfaces, you can cut off part of it.
Effect:
For models that are not very important at the bottom or need to be printed
separately, you can set the cut a certain height to print, the effect will be better.
5.
Double-headed overlap:
Double-headed printers need to be set for printing, and
repeats the amount of squeezing when setting the double-headed printing.
Effect:
Set a certain amount of repetitive extrusion, can make two colors stick tighter.
6.
Movement speed:
The speed of machine movement.
Effect:
The faster the movement speed, the shorter the printing time.
7.
Underlying print speed:
The speed of printing the bottom layer, low speed can stick
more tightly.
Effect:
The lower printing speed of the bottom layer can be adjusted appropriately to
make the bottom stick more tightly so that it can be printed better.
8.
Fill Speed:
The speed at which the fill is printed.
Effect:
Accelerate the fill speed and you can print faster.
9.
Outer wall speed:
print the speed of the outer wall, low speed printing can make the
outer wall print better.
Effect:
Decrease the printing speed of the outer wall can make the surface smoother.
10.
Inner wall speed:
prints the speed of the inner wall. Speed up can shorten the
printing time.
Effect:
Accelerate the print speed of the inner wall and shorten the printing time.
11.
Layer minimum printing time:
The minimum time for each layer of printing, when
the printing is too fast, the machine will be based on this. The minimum printing time
lower the speed to ensure sufficient cooling time.
Effect:
Control the minimum printing time for each layer of the machine to ensure
sufficient cooling time.
Содержание K300
Страница 1: ...1...
Страница 4: ...4 Chapter 1 Learn about your 3D printer 1 1 3D printer introduction...
Страница 5: ...5...