22
5.2.2 Full mode printing
Click
expert configuration
-
switch
to full mode
- select
“Yes”
.
You can see the full pattern with
various parameters, and see the details of
each parameter by mousing over the
options for the parameters.
The printed parameters can be set
according to the displayed information as
a reference.
5.2.3 Basic Setup
1.
Layer thickness:
The thickness of each layer filament supports 0.05-0.3, and it is
recommended to take values between 0.1-0.2.
Effect:
The smaller the layer thickness, the finer the surface, the longer the printing
time.
2.
Wall thickness:
The outer wall thickness of the model is 0.4 per layer filament, and it
is recommended to take values between 0.8 and 2.0.
Effect:
The thicker the wall thickness, the better the strength and the longer the
printing time.
3.
Allow reverse pumping:
Pull the filament back when printing.
Effect:
If not back pumping will produce filament drawing, affect the molding effect.
4.
Bottom/Top Thickness:
The thickness of the bottom and top.
Effect:
If there is a top hole in the print model, you can increase this value
appropriately.
5.
Fill rate:
0 is hollow and 100 is solid.
Effect:
Decreasing fill can save printing time but affect the intensity. Hollows can
sometimes be caused by too thin wall thicknesses, cannot complete model printing.
proper filling is sometimes necessary.
6.
Print speed:
Recommended 40-60mm/s.
Effect:
Adjust the speed appropriately so that there is enough cooling time when
printing, and the model can print better.
Содержание K300
Страница 1: ...1...
Страница 4: ...4 Chapter 1 Learn about your 3D printer 1 1 3D printer introduction...
Страница 5: ...5...