MAKERGEAR M2, Руководство пользователя, Страница: 7 / 24

Set Up
Carefully remove the foam from the
top of the printer and from inside the printer frame.
Remove the HBP from its slot in the foam and place it on
the 4 legged “Spider” inside the frame, with the glass
facing up. Remove the printer from the bottom foam.
Remove (and please read) WARNING sheet from
underneath your glass bed
by removing the binder clip.
Rotate the bed hold‐down clips to point toward the front
and back of the bed in order to secure the glass in place.
Unpack the power supply and set the Voltage Switch to
the voltage supplied through your outlet. There are only
two settings: 115 V (for 100 – 130 V) and 230 V (for 220 –
240 V). You must first determine your country's standard
voltage before using the M2 power supply ‐ using an
incorrect voltage setting may cause severe damage.
1
2
5
3
Install the Spool Holder with the four screws using the
3 mm allen key, ensuring that the longer side is facing up.
Place your PLA spool on the Spool Holder so that it
unwinds upwards through the Filament Guide and feed it
through.
Cut the PLA so the tip is flat, then feed the fila‐
ment into the Filament Guide Tube and into the Filament
Drive (If you have trouble feeding filament with a flat tip,
then try cutting it at a 45 degree angle).