Bend the thermocouple as little as possible.
26. Add the left side motor assembly.
The drive block should sit on top the the bar mount, with the motor at the back of the
bar mount. There is a depression in the bottom of the drive block that fits over the
cylindrical top of the thermal barrier tube.
27. Add the left side fan assembly to the front of the bar mount.
Insert the ends of the two left side fan assembly bolts into the holes on the left side of
the front face of the bar mount such that the bolts are at the bottom edge of the fan
and the fan leads emerge from the fan at the upper right corner.
Use the 2.5 mm hex wrench to tighten the fan bolts into the bar mount and motor.
28. Attach the left extruder fan leads to the extruder cable.
Connect the remaining white plastic connector coming from the extruder cable to the
corresponding connector coming from the left extruder fan.
29. Enclose the extruder cable wires in the wire wrapping.
Wrap the wire wrapping around the length of the bundle of extruder wires.
30. Attach the extruder end of the extruder cable to the plastic guide at the back of the
extruder.
Pull the zip tie very tight and clip off the excess.
31. Reattach the extruder cable to the back of the MakerBot Replicator 2X.
Move your extruders all the way to the front left corner of the MakerBot Replicator 2X.
Zip tie the cable to the clip at the top of the back of your bot, leaving a small amount of
slack on the cable. Push the cable into the other guides on the back of the bot.
Your MakerBot Replicator 2X is all set up to print again. Plug it in, turn it on, load up
some filament and try out your new bar mount.
