10
www.major-equipment.com
The following operations can be carried out by using the remote control:
1. Left wing Up, Left wing Down / Float
By keeping this key pressed, the left wing rises
up.
By releasing the key, the left wing stops.
By keeping this key pressed, the left wing
goes down and floats the same time. By pressing
the key again, descent and floating stop. A red LED
light indicates that the action is active (see diagram
below).
2. Rear deck UP, Rear deck DOWN/ Float
By keeping this key pressed, the rear deck goes
up.
By releasing the key, the rear deck stops.
By keeping this key pressed, the rear deck
goes down and floats the same time. By pressing this
key again, descent and float stop. A red LED light
indicates that the action is active.
3. Right Wing UP, Right Wing DOWN/Float
By keeping this key pressed, the right wing
rises up. By releasing the key, the right wing stops.
By keeping this key pressed, the right wing
goes down and floats the same time. By pressing
the key again, descent and floating stop. A red LED
light indicates that the action is active.
4. Rear deck top link block, Rear deck top link
transport
By keeping this key pressed the rear deck top
link. blocks. By releasing this key, the rear deck top
link unblocks.
By keeping this key pressed the rear deck goes
up/down. By releasing the key, the rear deck stops
moving.
TRANSPORT
Manual override
In the event of Manual Override, in order to lower wings, please follow this procedure:
1.
Turn off remote control (Disconnection is not necessary);
2.
Press the black tap in and turn it clockwise (Figure A);
3.
Turn the screw anti-clockwise until fully open (Figure B);
4.
Press the button fully (Figure C).
Figure B
Top screw (shown) -
right wing.
Bottom screw - left wing.
Figure C
Button shown will make the wing go down.
Button on the opposite side will raise the
wing.
This shows the normal
position, threaded in.
This shows the manual override
position with the thread out.
IMPORTANT - The check will not
work in this position & this should
be used for maintenance purposes
only. Manual override should not be
used when operating the machine
normally.
Figure A
PRESS
TURN
Press the knob in and turn
The knob will lock in this position
