www.major-equipment.com
16
1
1
2
2
A
B
C
Steel wheel
Every model is fitted with a wheel which stops the machine from bottoming out. It must belocated at the front outer edge
fo the machine. The wheel is factory set to suit most cutting conditions, however, it can be adjusted if required, to do so
remove 4 bolts shown and set to the required height.
1
Steel wheel
2
Adjustment bolts
Roller adjustment
In order to achieve desired cutting height, the roller should be adjusted.
Roller
To adjust the height of the roller follow this procedure at both
sides of the roller:
1. Loosen Bolt
C
(Note: You do not have to remove the bolt,
half of the turn will suffice to allow movement);
2. Remove Bolt
B
and locate in the desired slot
A
. (Note: Pay
attention when removing Bolt
B
as the roller may swing
down, adequate support must be provided under the roller);
3. Match the height of the roller on both sides of the machine
by checking the position of Bolt
B
in slot
A
;
4. When adjustment is complete, re-tighten Bolts
B
and
C
.
