17
16
SPECIFICATION
• Replacement of PU wheels
1. Replacement of wheels without a drive
a)
unscrew the nut fixing the PU wheel using the T-Tool provided with the
set.
b) remove the spacer from the PU wheel.
c)
pull off the PU wheel.
d) check if the second distance washer is on the hanger's axis, if so leave it
in place, if not, you can probably find it on the PU wheel bearing - put it
on the axle.
e) put on the PU wheel.
f) put the spacer on the hanger's axis.
g) screw the nut/cap so that the wheel does not slack and rotates freely on
the axis.
WARNING!
When replacing wheels from AT to PU and from PU to
AT, replace the self-locking nuts fixing the wheels on
the axis of the hanger or use an anaerobic adhesive for
safe tightening of the wheels.
2. Replacement of drive wheels
a) use the included small Allen key to unscrew drive belt cover.
b)
unscrew the nut fixing the PU wheel using the T-Tool provided with the
set.
c) remove the spacer from the PU wheel.
m) grasp the engine with one hand, move it upwards so that the toothed
belt is stretched. Use small force. With the other hand, tighten the 4
screws fixing the engine with a small Torx key. The strap should bend
lightly under the pressure of the finger, and the wheel should rotate
without much resistance. (Important! The engine mount should be
tightened only with a matching Torx key from the set, inserting it to the
end and tighten it with sensitivity so that you don't twist it).
3. Check if the motor and drive are working correctly without getting on the
board.
4. If the engine and drive are working properly, you can drive!
Содержание ONE AT
Страница 1: ...U S E R G U I D E ...