6
majacraft
Take the spinning head and slide it down into the handle. Push the JCB bolt in a little way through
the hole in the top of the handle. Align the wooden spacer tube in the handle so the bolt will can be
pushed through the centre.
6. Spinning Head
Required:
1 M6 60mm Gold JCB (2 1/2”) bolt
(in the handle
assembly)
4mm allen T wrench
(in the hardware bag)
1 Wood spacer tube
(in the handle assembly)
Spinning Head
Make sure the wooden nut has been removed from
the drive axle. Check that the star washer is on the
drive axle - if not, then slide the star washer on. The
black bushes must be in place on the front and back
of the Stem/Handle assembly.
Required:
Drive Wheel assembly
1 - Star Washer
(in the hardware bag)
1 - Wooden Nut
(wrapped separately)
5. Drive Wheel
Fit the drive wheel to the base assembly. Slide the drive shaft through the black bushes in the Stem/
Handle assembly from the back to the front. Screw the wooden nut on to the drive axle and tighten it
firmly.
5a
5b
5c
5d
5e
6a
