Unit:mm
Item
Description
Ground screw
Crimp one end of the grounding screw with the cold-pressed
terminal. The other end of the grounding wire is connected to the
ground, and the grounding wire is not less than 2.5mm2
Power interface
Support Dual DC9-60V.
Support single power input AC85-264V or DC110-370V.
Ethernet RJ45 port
Supports automatic MDI/MDI-X connection. You can connect the switch
to terminal devices, servers, hubs, or other switches.
Fiber port
The 100M fiber port is a 100Base-FX full-duplex single-mode or
multi-mode fiber connector, which support single-fiber or dual- fiber
connectors, and the connector can be SC, ST or FC. The optical
fiber connectors must be used in pairs (TX and RX are a
pair).
Din-rail kit
To fix the switch.
The indicator description of the switch is shown in the following table.
Indicator lights
Status
Definition
System Status LED
PWR1/PWR2
On
The power is connected and operating normally
Off
The power is not connected or the system is not operating
normally
RUN
Flashing
The system is operating normally (some models are always
on to indicate normally)
Off
The system is not working properly
Fiber Port Status LED
LINK
On
The port has established a valid network connection
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
RJ45 Port Status LED
Each RJ45 port has two indicator lights, the yellow light is the port plastic rate indicator, the
green light is the port connection status indicator.
10/100M
(Yellow)
On
100M working state (namely 100Base-TX)
Off
10M working status (namely 10Base-T)
Link/Act
(Green)
On
The port has established a valid network connection
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
Indicator lights
Status
Definition
System Status LED
PWR1/PWR2
O
n
The power is connected and operating normally
O
ff
The power is not connected or the system is not operating
normally
RUN
F
lashing
The system is operating normally (some models are always
on to indicate normal)
Off
The system is not working properly
Fiber Port Status LED
LINK
On
The port has established a valid network connection
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
RJ45 Port Status LED
Each RJ45 port has two indicator lights, the yellow light is the port plastic rate indicator, the green light is the
port connection status indicator.
10
/
100M
(Y
ellow)
On
100M working state (namely 100Base-TX)
O
ff
10M working status (namely 10Base-T)
Link
/
Act
(Green)
O
n
The port has established a valid network connection
F
lashing
There is network activity on the port
Off
No valid network connection is established on the port
Interface description
Ground screw
Power supply
35
100
140
Fiber port
35
RJ45 port
RJ45 port
