S3100 Install Manual (For S3100-9/18/26TC (TP)) V5.0
Please verify the sign above the port to ensure using the right port.
Connecting to wrong ports might damage the switch.
Fiber cables should be connected as below:
Step 1: Remove the protective plug from the SFP/XFP fiber transceiver
bore; Remove the protective cap from one end of the fiber cable. Keep the
fiber end clean and neat.
Step 2: Attach one end of the fiber cable to the SFP/XFP transceiver, and
attach the other end to the transceiver of the corresponding devices. Note:
The SFP/XFP transceiver’s TX port should be connected to the RX port of
the corresponding device, and vice versa.
Step 3: Check the fiber port status indicator, a lighted LED indicates that
the link has been established; otherwise the link is not ready and should
be examined.
Caution
Please verify the sign above the port to ensure using the other ports.
Connecting to wrong ports might damage the transceiver or the other
ports. When connecting other devices through a fiber cable to the switch,
the output power of the fiber cable must not exceed the maximum
received power of the corresponding modules. Otherwise, it will damage
the switch. Do not stare at the fiber bore when the switch is in operation.
That may hurt your eyes.
Power Supply Connection
MyPower S3100 use the power is 220VAC. Please read the power input
specification for the detailed information.
AC Power supply connection procedure is described as below:
Maipu Confidential & Proprietary Information
Page
25
of
26
