Maipu MyPower S4100 Series, Инструкция по установке, Страница: 22 / 23

MyPower S4100 Series Switch Install Manual (S4152F-POE-AC V2) V1.0
Maipu Confidential & Proprietary Information Page 22 of 23
Caution :
The input voltage should be within the required range, or switch can be
damaged or cannot work normally. If the power indicator is not blinking
even after power on or self-check is abnormal, contact the dealer or Maipu
Customer Service Center. Do not open the switch shell without permission.
It may cause physical harm.
Install External POE Power
External POE power PCR01-48/20 V3 is one mandatory power device of
SM4152F-POE switch, used for POE power supply. The output power is
500W.
The input power of external power PCR01-48/20 V3: AC power 100
240VAC, 50/60Hz; the back panel is as follows:
Connect the power as follows:
Step 1 : Put the AC input switch on the power back panel to OFF;
Step 2 : At the load output end of the power back panel, connect the DC
output cables correctly: green conducting wire to “48V+” and the red
conducting wire to GND. Use the ring end in the following cable to connect.
The cable is the power cable of PCR01-48/20 V3.
Step 3 : Connect the furcated end in the above figure to the POE input
port at the back panel of the MyPower S4152F-POE-AC V2 routing switch:
green conducting wire to 0V and red conducting wire to -52V, as follows: