Mainstreet Equipment 541CG1L, Руководство пользователя

Страница: 12 / 34

12 Mainstreet Equipment
User Manual
GAS CONNECTION:
1. The serial plate is located on the side panel. It indicates the type of gas the unit is equipped to use. All
equipment is adjusted at the factory.
2.
to the type of gas for which it is equipped.
3. A 3/4” NPT inlet is located at the rear for the gas connection. The external regulator provided with the unit
must be installed. An adequate gas supply is imperative. Undersized or low pressure lines will restrict the
volume of gas required for satisfactory performance.
4. An adequate gas supply line to the unit should be no smaller than ¾” diameter.
5. Purge the supply line to clean out dust, dirt, or other foreign matter before connecting the line to the unit.
6. All pipe joints and connections must be tested thoroughly for gas leaks. Use only soapy water for testing on all
ELECTRIC CONNECTION:
1. Before connecting the equipment to the network, check the following:
• Network voltage corresponds to the data written on the plate
•
• The connection cable is suitable to the power absorbed by the equipment
ELECTRICAL GROUNDING INSTRUCTIONS:
This equipment is equipped with a three-prong (grounding) plug for your protection against shock hazard
and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug.
EXHAUST SYSTEM:
1. This equipment must be positioned in suitable areas for the discharge of the combustion products in respect
2. This equipment must discharge the combustible products into appropriate hoods.
3. This equipment is not designed to be connected to an evacuation duct for the discharge of combustible
products.