Instructions for Hand Controller
NOTE
1. Make sure that there are no obstacles and that the desktop is not close to the wall during the lifting process.
2. Before use, please reset and ensure that all power cords are long enough to move the desk up and down.
1. Enter the reset state:
When the desktop is at the lowest position, press and hold the down button until the hand
controller displays RST, which will enter the reset state.
2. Exit the reset state:
Press and hold the down button until the desktop descends a short distance, then rises a
short distance and the hand controller returns to the display height to exit the reset state.
Phenomenon
The hand controller displays E07~E09.
Even after restarting after a power failure, the error display remains, and there is no
response to pressing any buttons.
Operation
Long press the down button until the hand controller displays RST, release the down
button, and long press the down button again until the hand controller displays the height
number.
Memory Height Setting
Up/down the desk to your ideal height, press the M button, and the hand controller will
display "S-", select and press any memory height button (1~4), the current desk height can
be memorized.
The next time you use it, you can directly press the memory height button to quickly reach
the previously memorized height.
Reset Steps
UP
Height
DOWN
Memory Heights
Set Up Button
“E07”
“E08”
“E09” “RST”
Long Press 5s
P
roduct manual
