Mahlkonig DK15 Series, Руководство по эксплуатации

Страница: 10 / 18

I N D U S T R I E M Ü H L E N | I N D U S T R I A L G R I N D E R
In case of other malfunctions or continued faults, please contact your dealer or your authorised customer service centre.
Defect
The grinder does
not start.
Defect
Grinder rotates
but without
grinding.
Cause
The power sup-
ply plug is not
inserted.
The overload
circuit breaker has
been tripped.
The pre-fuse was
tripped.
The motor
protector was
tripped.
Cause
Carrier breakage.
Incorrect sense of
rotation.
Metal parts on the
hopper magnet
obstruct the
incoming fl ow
of material to be
ground.
Remedy
Insert the plug into the outlet.
Check to determine whether
the reset button of the circuit
breaker has jumped out. Press
the reset button in again if ap-
propriate. In case of repeated
tripping of the circuit breaker,
contact your authorised cus-
tomer service centre or dealer.
Check the pre-fuse. Restore the
pre-fuse to its initial state or
replace it. Determine whether
other consuming devices are
also connected to this fuse.
Give the grinder a cooling-off
break of approx. 1 hr.
Remedy
Remove the grinder casing cov-
er, take out the broken pieces
of the driver, insert a new driver
and then install the grinder cas-
ing cover again.
Have the polarity checked by
specialised personnel.
Clean the hopper magnet.
9