MAGUIRE Weigh Scale Blender 4088 TSC, Установка, эксплуатация и обслуживание

Страница: 64 / 143

64
Saving Parameters
If the changes you have made are PERMANENT, SAVE them in the “User Backup Settings”.
A "Restore User Settings" will clear all data from memory and replace it with information stored in
the “User Backup Settings”. So it is a good idea to have an exact copy of User Settings stored in
the “User Backup Settings” for just such an emergency. To copy and SAVE all system parameter
information into the “User Backup Settings”, the sequence of keystrokes is as follows:
Press Display will prompt for a password. (default: 22222) Then press:
Press
System Configuration
Display will show the System Configuration categories.
Press
Resets
Display will show the categories of System resets:
User Settings, Factory Access, Restore Factory Defaults,
Firmware Update.
Press
User Settings
Categories will have several parameters indicated by a 3-letter
acronym on the left of the screen.
The Components category will have 12 materials, each with
several controlling parameters or groups of parameters.
Press
Save User Settings
Display will prompt for confirmation to save user settings.
Press
To save the user settings including parameters
or press the red X to cancel and exit.
With this done, all correct Parameters may be restored from EEPROM to RAM at any time by
doing a CLEAR.