MAGUIRE Weigh Scale Blender 4088 TSC, Установка, эксплуатация и обслуживание

Страница: 54 / 143

54
Blender Configuration
Parameters
Setup > Blender Configuration > Parameters
Parameters Introduction
Parameters – All WEIGH SCALE BLENDER controllers operate according to certain internal PARAMETERS.
Because customer requirements vary widely, we have made a wide range of parameters accessible for change
through the touchscreen. Parameters are grouped into the following categories: Control Times, Vibration Control,
Weight Limits, Components, Regrind Control, Mixer Control.
BRIEF explanations are given first.
FULL explanation is at the end of this manual (English manual version only).
Parameters values shown here are initial ROM values of a model 940. Initial values for
other models are listed at the end of this section.
Parameters are five digits, with leading zeros added.
TIMES TIMES are expressed as seconds, minutes, or interrupts.
(244 interrupts = 1 second).
WEIGHTS are always expressed as GRAMS.
100 and 200 models use tenths of grams: (xxxx.x). (00010 = 1 gram)
400/900/1800/3000 models; full grams: (xxxxx). (00010 = 10 grams)
PERCENTS are expressed in tenths for settings (0xxx.x), and full percent for other percentage
references (00xxx).
Navigating Parameters
Parameters are accessible from Setup. Parameters are grouped into the following categories:
Control Times DLY Delay Cycle Start (milliseconds)
DTI Weigh Bin Max Empty (seconds)
STL Settle Time Before Weight Reading (milliseconds)
SBO Sensor Blow Off (pulse count, pulse delay)
Vibration Control KDF Calibration Weight Reading Difference (1/10 th gram)
WDF Operation Weight Reading Difference (1/10 th gram)
BER Bailout Weight Limit (1/10 th gram)
Weight Limits FUL Full Batch Weight (grams)
MAX Maximum Bin Capacity Limit (grams)
TH Tare Weight Upper Limit (1/10 th gram)
TL Tare Weight Lower Limit (1/10 th gram)
Components
MATERIALS 1 thru 12:
RP Retry Limits – Allowed Percent Short
RD Retry Limits – Allowed Weight Short (1/10 th gram)
AL Retries Before Alarm
LA Lag Time (milliseconds)
WT Dispense Rate – Weight in 1/10 th of grams
TI Dispense Rate – Time in milliseconds
PO Pulsed Output / Timing (seconds)
SE Upper Limit
XT Format of decimal location 10ths or 100ths of grams
NC Limit Adjustment
MI Minimum Rate (g)