3 - Power Supply Replacement Procedure
ExpressCard 2000| Instant Issuance Card Personalization System | Power Supply Replacement Procedure
Page 11
Figure 3-6 – Power Supply Control and Monitoring Connector (LEFT VIEW)
9)
Use the No. 2 Philips screwdriver to loosen the screws holding the power supply output cables, then
disconnect the cables. See
Figure 3-7 - Power Supply Output Cables (LEFT VIEW)
10)
Use the No. 2 screwdriver to remove the four screws on the bottom of the device that hold the power
supply in place (see
on page 9).
11)
Remove the power supply and set it aside.
12)
If you are not immediately installing a replacement, with a partner, safely and carefully move the
device back to a stable operating position.