MAGSWITCH OPERATING MANUAL
For Drill Press Fence Tools
+ 1(303) 468.0662
magswitch.com
1101545 r01
For more information, contact our Application Engineers at +1.303.468.0662 or via magswitch.com
Page 2
Drill Press Fence Precautions
•
Always consider the orientation of load and center of gravity to avoid unnecessary “moments” or torques which can peel the
magnet away from the part.
•
Always test the connection before relying on the Drill Press Fence to ensure it is capable of holding the material securely.
•
Numerous factors can negatively affect the strength of the magnetic bond. Dirt, debris, oils and grease, painted surfaces and
any gap between the magnet and the metal surface will decrease the holding force. Ensure that the attachment/connection
point is clean and free of these factors for best performance.
•
Thicker metals will be held more strongly than thinner metals. For instance, ¼
” (6mm) steel will be held more strongly than
12 gauge (0.10
”) (
2.7mm) and other thin material.
•
Avoid sudden jerking or shock forces as this can cause the Drill Press Fence to lose its hold or slip.
•
This Drill Press Fence is NOT designed to be used as a welding ground clamp or as part of an electrical circuit.
•
For safe operation, the bottom surface of the magnet must always be flat and smooth. If necessary, it is possible to sand the
contact face smooth with 400 grit paper and a flat surface. Always file any burrs that interfere with full contact.
Drill Press Fence Setup
•
Use 3mm Allen key (included) to attach magnets to the fence (2 screws per magnet).
o
For large tables the ideal magnet position is 2 to 3 inches from the sides of the table with the fence
centered. This allows from an off-center positioning of the fence for operations that benefit from the taller
fence section directly behind the bit.
o
For smaller tables the ideal magnet position is close to the edges of the table to maximize the holding
power of the magnets.
•
The stop block can be stored out of the way on any ferrous metal surface. The user may find that the back side of
the fence provides a convenient and out of way place to store the stop block
Drill Press Fence Operation
•
Ensure that the bottom of the fence and drill press table is not coated with excess sawdust, as this can weaken
hold of the magnets.
•
Position the fence close to the desired distance from the bit and turn one magnet ON, taking care not to let the
fence tip over before the first magnet is turned ON.
•
With one magnet OFF and one ON, fine tune the position of the fence by moving the end with the magnet OFF
(pivoting around the magnet that is on). When the desired location obtained turn the second magnet ON.
•
If the drilling operation will penetrate through the workpiece it is recommended that a piece of sacrificial material
is used above the drill press table, put this in place now.
WARNING:
This product can expose you to chemicals including nickel and tetrafluoroethylene, which are
known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov
WARNING:
This product can expose you to chemicals including toluene, which are known to the State of
California to cause birth defects or other reproductive harm. For more information, go to
www.P65Warnings.ca.gov
