4.13 [105mm]
2.30 [58.4mm]
1.39
[35.2mm]
3.38
[85.8mm]
222 W. Memorial Road, Oklahoma City, OK 73126-0508
Phone: 1-800-624-7697 Fax: 405-755-8425
www.magpowr.com E-mail: [email protected]
INSTRUCTION MANUAL
MODEL DFC-A
DANCER-FOLLOWER ARM CONTROL WITH LOW VOLTAGE OUTPUT
All of the information herein is the exclusive proprietary property of Maxcess International, and is disclosed with the
understanding that it will be retained in confidence and will neither be duplicated nor copied in whole or in part nor
be used for any purpose other than for which disclosed.
Copyright 2004, all rights reserved.
Periodically there will be updates to this manual. The latest version is available at www.magpowr.com or by calling
1-800-MAGPOWR (624-7697).
1.0 Introduction
The MAGPOWR Model DFC-A is a complete solution for Follower Arm or Dancer control applications. The DFC-A
provides a 0 to 10 vdc or 4 to 20 ma output to control a current-to-pressure transducer, or a motor drive in torque
mode.
Terminals are provided for the connection of an external 1 madc current meter. The meter display will indicate
output as a percentage of the selected output range (0 to 10 vdc, or 4 to 20 madc).
The inputs and outputs are referenced to earth ground. The DFC-A operates on 24 vdc input.
2.0 Installation
The DFC-A is intended for installation on a vertical panel using a DIN 35 rail, using the wiring terminals facing
down. Figure 1 shows the enclosure dimensions.
All wiring should comply with the essential requirements of the appropriate standard(s) and is the responsibility of
the installer.
Route control signal wiring away from AC wiring. Connect shields of shielded cable to the terminals indicated as
“SHIELD”. Maximum shield length and maximum length of wires outside of the shield is 3 in. (75 mm).
Figure 1
Enclosure Dimensions
850A273-1
05/06 Rev. D
