Magnum MIG 160 Mini, Руководство пользователя

Страница: 14 / 18

14
-
welding speed,
- thickness, the type of the electrode and the work piece.
The amount of current is adjusted so that it could probably ignite the arc, and in the course of welding was steady and stable.
For example, the electrode "Pink 6012" needs to 2.0 mm - 40 to 60 A 2.5 mm - 50 to 70 A,
3.25 mm - 70 to 110 A, 4.0 mm - 110 ÷ 160 A, 5.0 mm - 160 ÷ 220 A.
8. CLEANING AND MAINTENANCE 8. CLEANING AND MAINTENANCE
Degree of protection of this device is IP21S, so, do not use the unit in the rain, or expose it to
moisture.
ATTENTION:
A device based on electronic components. Grinding and cutting in the vicinity of
the welding device can contaminate the swarf inside the device, thus leading to
damage. The above-mentioned damage is not covered by warranty! In the case of
having to work in such an environment must be made to clean the machine by blowing
compressed air inside of the welder.
To extend the service life and reliable operation, observe a few rules:
1. The device should be placed in a well-ventilated room, where there is a free circulation of air.
1. The device should be placed in a well-ventilated room, where there is a free circulation of air.
2. Do not place the device on a wet surface. 2. Do not place the device on a wet surface.
3. Use a wire diameter and a weight of the spool in accordance with disposed on the table. 3. Use a wire diameter and a weight of the spool in accordance with disposed on the table.
4. The cylinder protective gas set stable and secure by means of the chain against the possibility of tipping 4. The cylinder protective gas set stable and secure by means of the chain against the possibility of tipping
over.
5. Check the condition of technical equipment and welding cables. 5. Check the condition of technical equipment and welding cables.
6. Remove all flammable material from the welding area. 6. Remove all flammable material from the welding area.
7. Welding use suitable protective clothing: gloves, lab coat, shoes, a mask or helmet. 7. Welding use suitable protective clothing: gloves, lab coat, shoes, a mask or helmet.
When planning the maintenance of the device should take into account the intensity and operating conditions. Proper
use of the equipment and its regular maintenance will avoid unnecessary disruption and downtime.
Daily:
• Purify the handle by weight, and the gas nozzle chips, means lubricate against frangibility.
•
Check whether the cables are correctly connected.
•
Check the condition of the pipes. Replace damaged cables.
• Make sure that the device around the free flow of air.